With the new electric engine in place, we reconnect all the wires and install the vacuum pump. Put the tyres back on and it's system go.
Thursday, 6 September 2012
Completing The Circuit
Share
Popular Posts
-
The motor controller given to us was preprogrammed. We can just wire it in and run it, and we did. To win a race however, one has to evalua... -
When PROTON initially gave us the car , it was a Saga BLM 1.3 model. However for this competition, PROTON then decides to standardise the ca... -
It's October 5th, and finally, we're in Sepang International Circuit. The first day started with the registration and scrutinising o...
-
The concept of ICEV to EV conversion is simple enough where the original engine is to be replaced with the electric motor provided by the o... -
An electric vehicle battery (EVB) is a rechargeable battery used for the propulsion of battery electric vehicles (BEVs). For this PGMC 2012,... -
On 17 September, teams were again invited to the Sepang International Circuit, where the challenge will be held, for driver circuit familiar... -
After 9 months of hard work and 3 days of action, the PROTON Green Mobility Challenge 2012 comes to an end. The closing event started with t... -
In order to get an idea of where the hottest and coolest parts of the components might be, we made use of a thermal imager. This enables us ... -
When using batteries as the power source, a battery management system (BMS) is very important. It functions to monitor the battery pack'...
-
Electric vehicles (EVs) are propelled by an electric motor (or motors) normally powered by rechargeable battery packs. Electric motors have ...
0 comments:
Post a Comment